Power One AURORA MICRO-0.25-I-OUTD-US-208/240, Manual, Page: 18 / 78

Page
17
of
76 MICRO-0.25/0.3-I-OUTD-US-208/240 BCG.00612_AB
Part
1 Introduction and Safety
The instructions given in the manual do not replace the safety devices and technical data for
installation and operation mounted on the product. They do not replace the safety regulations
enforced in the country of installation and common sense rules.
The manufacturer is willing to train staff, at its premises or on site, in accordance with conditions to
be set out in the contract.
Do not use the equipment if any operating anomalies are found. Avoid temporary repairs.
All repairs should be carried out using only qualified spare parts, which must be installed in
accordance with their intended use and by a licensed contractor or authorized Power-One Service
representative.
Liabilities arising from commercial components are delegated to their respective manufacturers.
1.2.3.2
Thermal Hazard
Warning -
Certain parts may be extremely hot immediately following shut down
due to normal elevated surface temperatures (e.g. transformers, accumulators,
coils etc.).
Prior to touching any part of the inverter use care to ensure surfaces and equipment are at touch-
safe temperatures and voltage potentials before proceeding.
Anytime the inverter has been disconnected from the power network, use extreme caution as some
components can retain charge sufficient to create a shock hazard. To minimize occurrence of such
conditions, comply with all corresponding safety symbols and markings present on the unit and in
this manual.