Power One AURORA MICRO-0.25-I-OUTD-US-208/240, Manual, Page: 17 / 78

Page
16
of
76 MICRO-0.25/0.3-I-OUTD-US-208/240 BCG.00612_AB
Part
1 Introduction and Safety
1.2.3 S
AFETY
I
NSTRUCTIONS
Warning –
These servicing instructions are for use by qualified personnel only.
To reduce the risk of electric shock, do not perform any servicing other than that
specified in the operating instructions.
Be sure all flammable materials including construction items are away from the unit. Do not install
the inverter in or near potentially explosive areas.
Normally grounded conductors may be ungrounded and energized when a ground-fault is indicated
resulting in risk of electric shock. Test voltage with a voltmeter before touching.
Do not connect an AURORA MICRO inverter to the electrical distribution grid until after the receipt
of a letter of authorization from the authority having jurisdiction.
Install the AURORA Inverter in accordance with the electrical standards prescribed by the
applicable National Electric Code (NEC), Canadian Electric Code (CEC), and/or by other local codes
and regulations.
Use personal protective equipment; including gloves and eye protection when working on this unit.
1.2.3.1
General Information
The equipment has been manufactured in accordance with the strictest accident-prevention
regulations and supplied with safety devices suitable for the protection of components and
operators. Inform the manufacturer about non-standard installation conditions.
Maintenance operations must be carried out according to the Maintenance section in Part 6 of this
manual.
The connection of an inverter energy system to an electrical installation connected to the electricity
distribution network shall be approved by the appropriate electric utility.
It is essential to provide operators with correct information. They must therefore read and comply
with the technical information given in the manual and in the attached documentation.