Porter & Charles IR60S, Manual, Page: 8 / 39

9
Correct placement of oven shelves and roasting pans
76/90cm Oven 60cm. Oven
1
2
3
4
5
6
60/76cm Oven
The retractable slide runners can operate on shelf positions 2 through 6 by clipping or unclipping
them between the upper and lower rail of each shelf position.
The wire shelves can be inserted at any shelf position, or on the retractable slide runner.
The roasting pan can be inserted on shelf positions 1 through 5. It can be used with the
retractable slide runners for shelf position 6, but cannot be used with the slide runners for shelf
position 4.
When inserting the wire shelf, the riser should be positioned upwards at the rear of the oven. The
grooves at the sides of the shelves, toward the rear, provide an anti-slide stability for the shelves
when extended.
IMPORTANT: If the oven is ON, remember to switch it off manually otherwise it does not
stop operating in the set mode.
Cooling Fan
The oven is provided with a cooling fan motor to reduce the heat around the oven. The fan motor
is controlled by a sensor, which will start when the oven is switched on and stop working when
the temperature is reduced. This safeguards both the range and the adjoining cupboards from the
possibility of temperature damage.
Safety Thermostat
Your range is fitted with an over-temperature sensor that will automatically shut down your oven
for a short time if it is deemed to be overheating- this sensor is fitted to the rear wall of the oven,
inside the outer case
– it will only activate in extreme circumstances and is provided as protection
for the appliance and the adjoining furnishings. If activated, it will shut down the appliance for a
short time and will automatically reset, allowing normal operation. You should consult your
service technician if the problem re-occurs.