Polargos EASY WAY201, Manual

Page: 21 / 40

21
GB
ON/OFF
AUTO
PROG
ON/OFF
AUTO
PROG
3
Parameter setting
Programming of remote controls for complete opening only:
Select a remote control push-button to be used for the gate control.
Put the remote control in the place indicated on the housing:
1 Press the programming push-button and hold
it down until the indicator PROG starts flashing
slowly (the indicator DANGER will be alight
during push-button pressing).
2 Release the push-button: it has been memorized.
Programming of remote controls for opening for pedestrian entry or complete opening:
Choose a remote control push-button to be used for the gate control.
Put the remote control in the place indicated on the housing:
1. Press the programming push-button and hold
it down until the indicator PROG starts flashing
slowly (the indicator DANGER will be alight
during push-button pressing).
2. Release the push-button.
3. Press the programming push-button again
(no later than within 10 seconds) and hold it down
until the indicator PROG starts flashing slowly
(the indicator DANGER will be alight during push-button pressing).
4. Release the push-button: it has been memorized.
At the end of the programming cycle, only indicators PROG and ON/OFF emit light
however the electronic system is awaiting memorization of the path of the leaves.
Changing the operating mode of the programmed remote controls:
To switch the remote control from ‘complete opening only’ mode to the ‘opening for pedestrian
crossing or complete opening’ mode, it is enough to carry out the operations described above in
the section
‘Programming of remote controls for opening for pedestrian crossing or complete
opening’
. The latest settings will replace the previously programmed mode.
To switch the remote control from
‘opening for pedestrian crossing or complete opening’
mode
to ‘complete opening only’ mode, it is enough to carry out the operations described above in the
section ‘Programming of remote controls for complete opening only’ . The latest settings will
replace the previously programmed mode.