Plymovent MDB-2/Compact PRO, Installation And User Manual

Page: 8 / 20

0000104046/010822/A MDB-Compact PRO 10
ATTENTION
To make the unit level, make sure that you support
the angular points as well as the seam between the
filter housing (A) and the fan housing (B).
A
B
C
A
B
C
C
C
C
F
C
D
E
G
(M10x25)
C
A B
6 support points (bottom view)
Mounting on a platform or frame
If the unit is placed on a platform or frame, it must be
attached to this device.
Refer to Fig. IV on page 19 for the hole pattern
and external dimensions of the unit.
The package contains 4 screw studs 100 mm (3⅞ in.) with 4
locknuts.
Fig. 4.1
• Insert the 4 screw studs (A) in the bottom of the unit.
• Attach them to the platform or frame with the 4 locknuts
(B).
• Make sure that the unit is level.
Fig. 4.1
A (4x)
B (4x)
Mounting on platform or frame (image of frame is indicative
only)
4.5 Air inlet module and cover plate
MDB-2/C
The air inlet module and the cover plate are pre-installed on a
fixed position.
MDB-4/C and MDB-6/C
The air inlet module, the deflector plates and the cover plate
are supplied separately. Depending on your specific situation,
you can install the air inlet module:
Fig. 4.2
- on the left side of the unit (A); or
- on top of the unit (B)
1
2
4
3
A (8x)
A: Inlet left B: Inlet top
Fig. 4.2 Position of air inlet module
Fig. 4.3
• Disassemble the 2 corner plates with eye bolts on the top
left side of the unit.
Fig. 4.3 Corner plates with eye bolts
4.5.1 Deflector plates
Fig. 4.4
• Determine the preferred position of the air inlet module
(either left or top).
• Install the deflector plates (C) inside the filter module at
that position with the flange screws (A) and the bolt (B)
with washer and nut.
Fig. 4.4
B
A
C
Deflector plates