0000104046/010822/A MDB-Compact PRO
11
The open sides of the unit are provided with specially
constructed seals to make the unit airtight. You must use
SealApplicator (seal assembly lubricant) before you connect
any component to the filter module.
By the use of SealApplicator you can slightly shift
the component to get the right position. After
approx. 60 seconds the lubricant is dry so you
cannot shift anymore.
How to use SealApplicator:
4.5.2 Cover plate
• (1) Remove the backing material of the seals at the
position of cover plate.
• (2) Spray SealApplicator lubricant on the seals.
• (3) Put the cover plate
within 60 seconds
on the filter
module.
• (4) Attach the cover plate with the flange screws.
Fig. 4.5
1
2
4
3
Cover plate
If you have installed the cover plate on top:
• Re-install the 2 corner plates with the eye bolts
5
.
If you have installed the cover plate on the left:
• Put blinding plugs (A) in the remaining holes.
Fig. 4.6
A (8x)
Blinding plugs
5.
You must install the corner plates to make the unit airtight
4.5.3 Air inlet module
• Install the air inlet module in the same way as the cover
plate (refer to paragraph 4.5.2).
4.6
Filter cartridges
To install the filter cartridges, do the following.
• Loosen the star knob (F) and disassemble the cover plate
(E), the nut (D) and the metal washer (C).
• Put the filter cartridge (B) on the cartridge holder (A).
• Install the removed parts in reverse order.
Fig. 4.7
B
A
D
C
E
F
Installation of the filter cartridges
ATTENTION
Make sure that the front of the filter cartridge
aligns
*)
with the filter housing, so that the lid closes
well. If this is not the case, the filter cartridge is not
positioned correctly. This can cause leakage and less
efficient operation of the filter cartridge.
*)
tolerance: max. 2 mm (⅛ in.)
>2 mm
max. 2 mm
>2 mm
max. 2 mm
>2 mm
max. 2 mm
>2 mm
max. 2 mm
