Plus M-17S, User Manual

Page: 9 / 28

E-9
The copyboard uses a CIS (Contact Image Sensor) image sensor to read the diagrams and text that have been
written down with special markers, and accumulates the image data in internal memory. The sheet surface's
image data is printed out from the printer when the B/W Print (
) button is pressed, or stored as image data
on the USB memory device or in the main unit's internal memory when the Save ( ) button is pressed. Note
that prints are made in black & white and images are stored in grayscale.
Preparation
• Set up the newly purchased copyboard and connect a printer.
See a separate manual titled “Assembly and Setup Manual.”
• Plug the AC power plugs of the copyboard and printer into wall power outlets. See page E-10.
• After purchase, be sure to set the copyboard's clock. If not, the proper date and time will not be displayed on
prints or in image files. See page E-21.
Draw on the Sheet Surface
Please draw with the dedicated markers that have been supplied.
If anything other than the dedicated markers or eraser are used, it may be impossible to erase the
sheet or the sheet could get dirty.
To move the sheet manually, see “Moving the Sheet Surface Manually” on page E-13.
Saving to USB Memory
(1) Press the ON/Standby button of the copy-
board to switch on the power.
(2) Insert USB memory into the Memory port
(USB A port) of the copyboard.
(3) Press the Save button.
See “Using USB Memory” on Page E-14.
Saving on a computer
(1) Press the copyboard's ON/Standby ( ) button to
turn the power on.
(2) Connect the copyboard to the computer using the
PC dedicated USB port.
(3) Press the Save ( ) button.
(4) The image is saved on the computer.
• When connecting the power plug, the fl ashing LED indicator in the display window starts to rotate for about 5 seconds.
Make sure to press the On/Standby button to power on the copyboard when the fl ashing LED indicator goes off.
* If letters are blurred, lines are thin or markers overlap, it may not be possible to scan some parts. Also, ruled lines may be
scanned.
• Data in the internal memory is cleared when the power is turned off (set to standby) with the ON/Standby button or when
the computer is disconnected.
Operation Steps
Printing
(1) Set A4 or letter size paper.
Do not set anything other than A4 or letter size
paper.
(2) Press the ON/Standby button of the copyboard and
switch on the power.
(3) Switch on the printer power.
For instructions on operating the printer, see the
printer’s operating instructions.
(4) Press the B/W Print button. The copyboard
will move a one-screen portion of sheet, read the
image, and start the copy operation*.
See “Printing” on Page E-11.
When Not Using the Copyboard
(1) By all means, cleanly erase the drawing from the sheet surface with the dedicated eraser. (Leaving the drawing for a
long period will make it harder to erase.)
(2) Press the ON/Standby button of the copyboard and switch off the power (standby mode).
The power cannot be switched off while the USB memory remains installed. (This is a prevention function against
forgetting to unplug the USB memory.)
(3) Switch off the printer power.
Note