40
CONNECTION TO THE SET
12-3. Wiring the cables in the cable cover(s)
The place of installation of the cable covers included with the main unit differs for the standard type and wide
type. (Note that they cannot be attached to the stand.) Also, the cable cover included with the stand and de-
signed specifically for the stand cannot be attached to the main unit.
Standard type: One cable cover specifically for the main unit
Wide type: Two cable covers specifi cally for the main unit
Stand: Two cable covers specifically for the stand (Narrow type x 1, Broad type x 1)
Narrow type: Use this for a 100V power cord
Broad type: Use this for a 200V power cord
(1) Attach the cable cover(s) according to the type you
have purchased.
• Peel off the backing paper from the cable cover and
attach the cable cover firmly to the bracket.
[When the main unit is installed on a wall]
Attach the cable cover to the side of the bracket.
• For the wide type, also attach one of the cable cov-
ers specifically for the main unit to the bottom of the
main unit.
• Insert the cable/cord into the slit in the cable cover.
* If the cable/cord is too short or too long, remove
the screws from the AC adapter box and adjust
the length.
Notice
• The included cable covers use a powerful adhesive
seal.
The cable cover may be damaged or deformed if you
try to remove it and attach it in a different position.
Check the position of installation of the printer table
before attaching the cable cover.
Bracket
Cable cover
