37
DISASSEMBLY AND ASSEMBLY
Fig. 12
10) Remove the Endless Sheet. (See Figs. 13, 14, and 15.)
1. Push the sheet roller section inside as shown in
Figs. 13 and 14.
2. Remove the Endless Sheet as shown in Fig. 15.
Note:
• Be careful not to damage or fold it when handling
the Endless Sheet.
Fig. 13
Fig. 14
Fig. 15
Fig. 16
11) Remove the LED Unit. (See Fig. 16.)
1. Remove the LED Harness as shown in Fig. 16.
2. Remove the “S-3” screws as shown in Fig. 16.
3. Remove the LED Unit as shown in Fig. 16.
Note:
Use the parts assembled in a factory during replace-
ment of an LED unit.
* Calibration is required after replaced.
Endless Sheet
9) Remove the Sensor Board Unit. (See Fig. 12.)
1. Remove the “S-3” screws shown in Fig. 12 and then
remove the Sensor Board Unit.
Note:
Be careful not to damage the White Sheet when the
Sensor Board Unit removed and installed.
S-3
Sensor Board Unit
Endless Sheet
S-3
S-3
LED Unit
LED Harness
