26
FeederPro Model 1000/1010 Operator Manual
T10160
This menu appears directly when the yellow Setup Guide
button is pressed or after finishing programming the ma-
chine.
Select type of finishing using the “Up/Down” arrow buttons.
“Integral Stacker”.
Use the “Up/Down” arrow buttons so select between:
“Offset”.
Offset stacking.
“Straight”. Straight stacking. The integral stacker moves so
that the fed sets will be stacked evenly.
“Tray”.
The integral stacker does not move at all.
“External Stacker”
Use the “Up/Down” arrow buttons so select between:
“Offset”.
Offset stacking.
“Straight” Straight stacking.
“Booklet maker”
The set will be delivered to the booklet maker.
Use the “Up/Down” arrow button to select this option.
4.7.4 Finishing (Collator and Feeder mode)
Press the letter button ”A”, ”B” or ”C”, corresponding to the
block from which the first sheet should be fed from. Then
press the letter button ”A”, ”B” or ”C”, corresponding to the
block from which the second sheet should be fed from, and
so on, until the complete feeding sequence has been
entered. Press the ”OK” button to end the programming.
After pressing the ”OK” button, a table showing the
programmed sequence will be shown. To confirm the
programmed sequence and to start the calibration, press
the ”OK” button. If option ”Active feed is used, no calibration
will be made.
4.7.3 Learn Feed Sequence (Feeder mode only), cont
Summary of Contents for FeederPro 1000
