Plockmatic FeederPro 1000, Operator'S Manual

Page: 22 / 37

FeederPro Model 1000/1010 Operator Manual 21
T10160
4.2.1 Insert Sheet Mode
Enter the “Insert Sheet Mode” menu.
This program allows you to separate a stack of sets by
inserting a slip sheet. Select how many sheets to be fed,
before the slip sheet will be inserted, by using the ”+” or “-”
buttons. The step function will start slow and then accelerate.
Press the ”OK” button to confirm.
The calibration set does not affect the insertion sheet coun-
ter. Follow the procedure in section 4.7 to calibrate and start
the job.
Follow the procedure in section 4.7 to calibrate and start the
job.
Note : The insertion sheets must be loaded in the next bin below
the sheets that should be in the set.
4.2.2 Alternate Bin Mode
Enter the “Alternate Bin Mode” menu.
This program allows you to run the collator continuously. You
can reload the collator while running by loading the same
sheet in two bins. As soon as any bin is empty the collator
automatically switches to the alternate bin. With one tower it
is possible to load up to 4 sheets per set (with two towers - 8
sheets and with three towers up to 12 sheets). Mark the total
number of bins to be used with the arrow buttons. The
marked bins will be shown inverted. Press the “OK” button to
confirm.
Follow the procedure in section 4.7 to calibrate and start the
job.
Note 1: Load sheet one in bin 1 and bin 2, sheet two in bin 3 and
bin 4 and so on.
Note 2: After reloading, press the up arrow button to activate the
reloaded bin/s to achieve continous running.
4.2.3 Alternate Cover Mode
Enter the “Alternate Cover Mode” menu.
This program doubles the loading capacity of covers by
allowing you to load the cover sheets in both bin 1 and bin 2.
Use this program when the covers are thicker than the body
sheets. Select “Alternate Cover Mode” with the arrow but-
tons. Press the “OK” button to confirm.
Follow the procedure in section 4.7 to calibrate and start the
job.