Plockmatic FeederPro 1000, Operator'S Manual

Page: 18 / 37

FeederPro Model 1000/1010 Operator Manual 17
T10160
After a successfully completed calibration, the screen
”CURRENT JOB” will be shown. From this screen you can
also choose to clear the counter by pressing the ”CLR”
button, to save the job by pressing the ”MEM” button or to
change settings made by pressing the ”ADJ” button.
3.11 Running a job using Model 1000 as a Feeder, cont.
If you are satisfied with your programmed settings, press the
green Start/Stop button to start the job.
This screen will be shown while the job is running.
When stopping a job press the ”softstop” button. This
function will feed the complete preset sequence before
stopping. Next time the green Start/Stop button is pressed,
the machine starts feeding next preset sequence.
If stopping a job with green Start/Stop button, the job stops
immediately. Press green Start/Stop button and the
sequence continous where it was stopped.
NOTE: If a jam occurs, when pressing green Start/Stop button it
always starts with the first sheet in the sequence. Therefore it is
important to reload/unload bins in use to correct sequence limit.
Soft stop