STEP 3: RIGHT CORNER POSTS AND SAND BOX BOARDS
1: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE
DIAGRAM BELOW.
2: ATTACH THE 2 X 6 X 47-3/8" END SAND BOX BOARD (HOLES OFFSET DOWN) TO THE FRONT
SIDE OF THE RIGHT CORNER POST USING ONE 5/16" X 4-1/2" HEX BOLT AND 5/16" WASHER.
3: ATTACH THE 2 X 6 X 47-3/8" END SAND BOX BOARD (HOLES OFFSET DOWN) TO THE REAR SIDE
OF THE RIGHT CORNER POST USING ONE 5/16" X 4-1/2" HEX BOLT AND 5/16" WASHER.
RIGHT CORNER POST
5/16" WASHER
FRONT
OF PLA
Y SET
T-NUT
T-NUT
(REAR POSITION)
HEX BOLT
5/16" X 4-1/2"
5/16" WASHER
5/16" X 4-1/2"
HEX BOLT
RIGHT CORNER POST
(FRONT POSITION)
33
