TORQUE WASHER
3/8" WASHER
3/8" LOCK NUT
BOLT CAP
4 X 4 X 54"
6-1/2" CARRIAGE BOLT
CORNER POST
4 X 4 X 34-3/4"
CORNER POST
1: FIND FOUR 4 X 4 X 54" CORNER POSTS. THE ORIENTATION OF THE POSTS ARE IMPORTANT IN THIS STEP. THE SINGLE
COUNTER-SUNK HOLE AT THE TOP OF THE POSTS MUST FACE TOWARD EACH OTHER.
2: THE CORNER POSTS WILL ATTACH IN THE PRE-DRILLED HOLES WITH THE BOTTOM COUNTER-SUNK HOLE OF THE
CORNER POSTS LINING UP WITH THE TWO HOLES IN THE MONKEY BAR ASSEMBLY CLOSEST TO THE LADDER ASSEMBLY.
3: ATTACH THE CORNER POSTS WITH A 6-1/2" CARRIAGE BOLT WITH A TORQUE WASHER FROM THE INSIDE OF THE
MONKEY BARS, AND 3/8" LOCK NUTS WITH 3/8" WASHERS FROM THE OUTSIDE. PLACE GREEN BOLT CAPS OVER ANY
EXPOSED THREADS.
5: FIND TWO 4 X 4 X 34-3/4" CORNER POSTS. THE CORNER POSTS WILL ATTACH IN THE PRE-DRILLED HOLES WITH THE
BOTTOM COUNTER-SUNK HOLE OF THE CORNER POSTS LINING UP WITH THE HOLE AT THE END OF THE MONKEY BAR
ASSEMBLY.
6: ATTACH THE CORNER POSTS WITH A 6-1/2" CARRIAGE BOLT WITH A TORQUE WASHER FROM THE INSIDE OF THE
MONKEY BARS, AND 3/8" LOCK NUTS WITH 3/8" WASHERS FROM THE OUTSIDE. PLACE GREEN BOLT CAPS OVER ANY
EXPOSED THREADS.
7: DO NOT USE ANY HARDWARE IN THE TOP HOLES OF THE CORNER POSTS AT THIS TIME, THEY WILL BE USED LATER.
STEP 42: CORNER POSTS
61
