26
Assembly Instructions
(2) 1-1/4'' screws
Swing Hanger
Use Screwdriver to aid in tightening
Bottom Beam Clamp
T-nut
Hammer
3/8'' hole
Bottom Beam Clamp
Swing Hanger
Swing
Beam
Swing Hanger Assembly
1.
Tap 5/16'' T-nut into 3/8’’ hole as shown in
(Step 1)
.
2.
Place a bottom beam clamp over the swing hanger as shown in
(Step 2)
.
3.
Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the T-nut.
A screwdriver may be used to twist the hanger, as shown in
(Step 3)
.
4.
Orient swing hanger as shown in
(Step 4)
. Use (2) 1-1/4'' screws to secure beam clamp.
5.
Make certain the Swing Hanger is seated in the Beam Clamp Slot to prevent spinning.
6.
Repeat for all swing hangers.
NOTE:
Make certain to alternate Swing Placement on
both
Swing Beams.
DO NOT
place all swings on a single beam.
5/16''
T-Nut
5-1/4'' Swing Hanger
5/16''
T-Nut
1-1/4'' Wood Screw
