PLATFORM BASKET RR 14 EVO 2-400 Hybrid, Use And Maintenance Manual

Page: 114 / 150

RR 14 EVO 2-400 HYBRID
11.7. PREPARING THE MACHINE FOR
MAINTENANCE
If maintenance must be performed under the
turret, a switch is present inside the control
board on the ground that allows to lift the turret
using the compensation cylinder.
By holding the operator present button down
(SB80) , turn switch (SA79) to the right or left
to lift or lower the turret from the cylinder side.
To "disconnect the machine from energy
sources" and set it up so that maintenance can
be carried out in total safety, proceed as
follows:
‒ Disconnect the batteries of the machine by
removing the connector terminals.
‒ Disable the engine by rotating the key in the
battery disconnector to off.
‒ Remove the activation key so that no-one can
power up the machine during maintenance
work.
GRUPPO
‒ Affix the "Maintenance in progress" sign.
11.8. CLEANING
After every trip and every intervention, clean carefully the equipment (joints, pins, sliding pads).
Keep handles and decking free of oil, grease and dirt to minimise the risk of slipping and falling.
When you wash the machine, protect properly its components and electric connections, because using direct
and under pressure jets on equipments and electric connections could cause damages.
To avoid rapid wear of seals remove dust, debris and dirt from the jack rods using non-abrasive detergents.
I
Caution
This procedure must be performed with care to avoid scratching or scoring the rods.
‒ Clean impurities and dirt on controls.
‒ The carpentry protected by paint has to be cleaned with water and non-corrosive cleansers.
We suggest you to dry carefully after every washing (by blowing compressed air).
i
Danger
It is strictly forbidden to address water jets near electric components (boards, electric valves, push button,
etc.) and oil plugs.
English
114/150