PLATFORM BASKET RR 14 EVO 2-400 Hybrid, Use And Maintenance Manual

Page: 104 / 150

RR 14 EVO 2-400 HYBRID
ULTIMO BRANO TABELLA
Oil loosing from the cylinders tops
Causes Remedy
Ruined cylinder seals.
Too slow end cap on rod.
Cylinder with swelled outer casing.
Rust under seals setting place.
Replace cylinder seals.
Unfasten end cap, clean and reassemble
with loctite.
Replace cylinder.
Replace only the ruined component.
ULTIMO BRANO TABELLA
The machine seeps much oil of connectors and of seals generally
Causes Remedy
General seal ruined.
Too slow fittings.
Too warm oil.
Few oil in tank.
Too old or ruined system rubbers.
Fasten fittings or check however their
sealing.
Add oil in tank.
ULTIMO BRANO TABELLA
The main or auxiliary engine does not start
Causes Remedy
Starter motor fuse burned. Replace the fuse with one with equal
amperage.
ULTIMO BRANO TABELLA
The electric plant does not function
Causes Remedy
The magnet-circuit breaker has tripped. Restore the magnet-circuit breaker (Q1),
positioned inside the control board on the
ground, taking it from OFF to ON.
ULTIMO BRANO TABELLA
Control valve lever which stops or which comes back hardly
Causes Remedy
Dirt into the spool.
Ruined spool.
Return spring too weak or broken.
Too much friction on the shaft of the
double command.
CE cylinders, which do not discharge
pressure.
Radio module stop or always in voltage.
Too back pressure in control valve
discharge.
Cursor opening and closing badly done.
Sealing OR which produce too friction.
Assembled control valve and tie rods too
strongly fastened.
Too strongly fastened rod-side or opposite
side caps.
Disassemble and clean spool even with
paste erasing micro-impurities.
Replace spool.
Replace springs.
Unfasten double control rod and set it.
Check discharge pressure from the CE
cylinders.
Check pressure on draining.
replace OR seals.
Check with a dynamometric key the control
valve tightening tie rods.
Slacken caps screws.
Clean with air the control valve element.
English
104/150