Display :
FSTN LCD 128Vx64H
Backlighting : White LED
Power Requirement:
4-AAA alkaline Batteries
8 Attachments:
1)Handheld Transducer with 7m Cable
Depth Range Max : 70m
3
2)Neck Strap
Operational Temperature:
from -20°C to 70°C
Depth Range Min : 0.6m
7 Product specification:
Measure Units: Feet and meters
Sensor Beam Angle: 45 degrees
6.1 SIDE-SCAN
5.10 Temperature Unit
5.9 Depth Unit
4
5.8 Chart Speed
6 HOW TO USE THE SIDE-SCAN
TRANSDUCER
ON THE SEASHORE
ON THE BOAT
This SIDE-SCAN Transducer can be used from bridges,
boats or the seashore etc.
NOTE:
Remove the batteries from the fish finder to prevent
battery leakage and corrosion.
Clean the sonar sensor and cable with fresh water and
dry-off before storing .Do not submerge and/or spray
the fish finder screen/housing with water or use
chemicals to clean.
(Setting Saved in Memory, 1 to 5)
Press POWER-MENU until the CHART SPEED menu
appears. Select a setting from 1-4 to increase or
decrease the chart speed, where 1 is the slowest and 4 is
the fastest chart speed.
(Setting Saved in Memory)
Press POWER-MENU until the DEPTH UNIT menu
appears. Select either FT or M to set the unit of depth.
(Setting Saved in Memory)
Press POWER-MENU until the TEMP- UNIT menu
appears. Select either C or F to set the unit of
temperature.
The Side-Scan Transducer has the ability to be used
as a sideways scanning sonar fish finder to detect the
bottom contour and fish locations.
1. Connect the transducer cable to the main unit and
turn power ON, select START UP mode for use.
2. Place the transducer as perpendicular as possible
to the water to obtain a correct depth reading.
3. Move the transducer in a scanning motion (similar
to use as a flashlight),and the bottom contour and fish
locations will be showed on the screen.
NOTE:
There may be a wrong
display on the screen if you
use this SIDE-SCAN
Transducer in the situation
like the pictute below . As the
Side-SCAN function request
more rigorous environment, if
the banks is too gradually
and looks flat, or too much
sundries and weed in the
banks, you have to change
another place to retry to
make sure the Side-Scan
function to work well.
