Plastimo 68756, Instruction Manual

Page: 53 / 376

53
■
Installation of Connecting Cables
When connecting the external speaker, GPS, DC power supply, computerand navigation device by the
rear panel cable end, cover the connectors and cables with rubber vulcanzing tape as below, to prevent
water seeping into the transceiver.
1. External Speaker and Programming Data Leads
● Connect an external speaker to Blue and Black Lead.Blue
→
Positive Electrode (+), Black
→
Negative
Electrode(-).
● Connect programming cable to Black and Grey Lead.
2.NMEA In/Out Leads
Through the rear panel lead, this transceiver can connect GPS input signals from GPS receivers, and can
also output GPS signals to other devices.
● Input Connection: Connect to the NMEA output line (port) of the GPS receiver for location data, connect
as follows:
Green
→
Receiving Data, GPS Input (-); Yellow
→
Receiving Data, GPS Input (+).
NOTE: GPS receiver is required to be compatible with NMEA0183 version 2.0 or above, statement format
RMC, GGA, GNS, GLL.
● Output Connection: Connect the output to the navigationdevice input line (port) that supports NMEA0183
for receivinglocation data from other ships, connect as follows:
Brown
→
Sending Data, Data Output (-); White
→
SendingData, Data Output (+).
NOTE: The output signal of this transceiver complies with NMEA0183 version 2.0 or above, compatible
with DSC, DSE navigation equipment, statement format RMC, GSA, GSV.
3.External GPS Antenna
Connect to the external GPS antenna, included.
NOTE : Make sure that the GPS antenna is installed in an open, unobstructed position so that the satellite
signal can be received well. When installing the GPS antenna, use the supplied double-sided tape to fix
it.
4.Ground Terminal
Connect this terminal to a vessel ground to prevent electrical shocks and interference from other
equipment occurring. Use a PH M3
×
6 mm screw (not supplied).
5.DC Power Connector
Red
– Positive (+), Black – Negative (-).The output voltage of the connected DC power supply must be
13.8V, do not connect the transceiver to the 24V storage battery. If the current supplied to the transceiver
is insufficient, the display may darken during transmission or the transmitting output power may drop
significantly.