Planet IGSW-2840, User Manual

Page: 654 / 671

User’s Manual of IGSW-2840
654
Requests will be broadcast periodically by this device in an effort to learn its IP address. (BOOTP and DHCP values can
include the IP address, default gateway, and subnet mask).
You can start broadcasting BOOTP or DHCP requests by entering an ip dhcp restart command, or by rebooting the
switch.
Only one VLAN interface can be assigned an IP address (the default is VLAN 1). This
defines the management VLAN, the only VLAN through which you can gain management
access to the switch. If you assign an IP address to any other VLAN, the new IP address
overrides the original IP address and this becomes the new management VLAN.
Example
In the following example, the device is assigned an address in VLAN 1.
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#
Related Commands
ip dhcp restart
ip default-gateway
This command establishes a static route between this switch and devices that exist on another network segment. Use the no
form to remove the static route.
Syntax
ip default-gateway gateway no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
A gateway must be defined if the management station is located in a different IP segment.
Example
The following example defines a default gateway for this device:
Console(config)#ip default-gateway 10.1.1.254
Console(config)#
Related Commands