Planet IGSW-2840, User Manual

Page: 424 / 671

User’s Manual of IGSW-2840
424
radius-server host
This command specifies primary and backup RADIUS servers and authentication parameters that apply to each server. Use the
no form to restore the default values.
Syntax
[no] radius-server index host {host_ip_address} [auth-port auth_port] [acct-port acct_port] [timeout timeout] [retransmit
retransmit] [key key]
index - Allows you to specify up to five servers. These servers are queried in sequence until a server responds or the
retransmit period expires.
host_ip_address -IP address of server.
auth_port - RADIUS server UDP port used for authentication messages. (Range: 1-65535)
acct_port - RADIUS server UDP port used for accounting messages. (Range: 1-65535)
timeout - Number of seconds the switch waits for a reply before resending a request. (Range: 1-65535)
retransmit - Number of times the switch will try to authenticate logon access via the RADIUS server. (Range: 1-30)
key -Encryption key used to authenticate logon access for client. Do not use blank spaces in the string. (Maximum length:
48 characters)
Default Setting
auth-port - 1812
acct-port - 1813
timeout - 5 seconds
retransmit - 2
Command Mode
Global Configuration
Example
Console(config)#radius-server 1 host 192.168.1.20 auth-port 181 timeout
10 retransmit 5 key green
Console(config)#
radius-server auth-port
This command sets the RADIUS server port used for authentication messages. Use the no form to restore the default.
Syntax
radius-server auth-port port_number no radius-server auth-port
port_number - RADIUS server UDP port used for authentication messages. (Range: 1-65535)
Default Setting