Planet IGSW-2840, User Manual

Page: 529 / 671

User’s Manual of IGSW-2840
529
rate-limit
This command define the rate limit for a specific interface. Use the no form to restore the default status of disabled.
Syntax
rate-limit {input | output} scale {1k | 10k | 100k | 1m | 10m} level level no rate-limit {input | output}
input – Input rate limit
• output – Output rate limit
scale – The traffic rate limit scale. (Options: 1K, 10K, 100K, 1M, or 10M bytes per second)
level – The traffic rate limit level. (Range: 1-127)
Default Setting
Status: Disabled
Scale: 10M bytes per second
Level: 1
Command Mode
Interface Configuration (Ethernet)
Command Usage
The scale and level are multiplied by one another to set the rate limit. For
Example
, to limit port traffic to 500K bytes per
second, select the scale as 100K and set the level to 5.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input scale 100k level 5
Console(config-if)#
5.19 Address Table Commands
These commands are used to configure the address table for filtering specified addresses, displaying current entries, clearing
the table, or setting the aging time.
Command Function Mode
mac-address-table static Maps a static address to a port in a VLAN GC
clear mac-address-table
dynamic
Removes any learned entries from the forwarding database PE
show mac-address-table Displays entries in the bridge-forwarding database PE
mac-address-table aging-time Sets the aging time of the address table GC
show mac-address-table
aging-time
Shows the aging time for the address table PE
Table 5-61 Address Table Commands