35
8 - MANUTENZIONE
Planet
200 T-H / 200 TS-H
8.5 - Failures research
FAILURE
CAUSE
SOLUTION
T H E V A C U U M
CLEANER DOESN’T
START (green light off)
Lack of voltage
- Check that the voltage is present in the socket
- Check if the plug and the cable are undamaged
- Ask assistance to an authorised technician
T H E V A C U U M
CLEANER TURNS OFF
DURING THE SERVICE
Intervention of the thermic
protection due to obstructed
filter or problems to the
electrical system of the
equipment.
- Check that the light (green) located on the vacuum cleaner ison. In
this case there is an intervention of the thermic protection. Switch off
the single motors. Clean the filter. Wait 20/25 minutes
before starting the vacuum cleaner again.
- If the light (green) is off, in this case there is an intervention of the
feeder protection that avoids its overload.
- Check if the electrical feeder is consistent with the vacuumcleaner power.
- Check the electrical functionality of the vacuum cleaner, asking for
authorised technical assistance.
T H E V A C U U M
CLEANER IS TOO
NOISY (the head
issues very strong
vibrations)
Excessive dirt deposit on the
motors turbines (eventual
breaking or misfunctioning
of the filter)
- Clean the motors turbines (see page 31)
- Ask authorised technical assistance
T H E V A C U U M
CLEANER DOES NOT
SUCK THE DIRT
- Obstructed filter
- The suction hose is
obstructed
- Gaskets seal
The manometer is on the red zone and the red light is on.
Turn off the vacuum cleaner and shake/replace the filter.
Turn off the vacuum cleaner and clean/replace the suction hose.
Turn off the vacuum cleaner and check the efficiency of the tank gaskets
T H E V A C U U M
CLEANER INPUTS
DUST
Breaking or misplacement
of the filter
Turn off the vacuum cleaner and replace the filter or place it again
correctly, after having carried out a careful cleaning.
T H E V A C U U M
CLEANER FEATURES
O N E O R M O R E
MOTORS OFF
Worn carbon brushes
Ask for technical assistance for the replacement of the carbon brushes
and for the functional control of the motors.
T H E V A C U U M
CLEANER FEATURES
E L E C T R O S TAT I C
CHARGES ON THE
FRAME OR ON THE
SUCTION HOSE
Lack of or bad grounding
Turn off the vacuum cleaner and check the efficiency of the grounding
of the electrical feeder. Make sure that you are using an antistatic
suction hose.
