Planet Networking & Communication WGSW-24040, User Manual

Page: 31 / 576

User’s Manual of WGSW-24040 / WGSW-24040R
Reset Button Pressed and Released Function
< 5 sec
: System reboot Reboot the Managed Switch
> 5 sec
: Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
Default Username:
admin
。
Default Password:
admin
。
Default IP address:
192.168.0.100
。
Subnet mask:
255.255.255.0
。
Default Gateway:
192.168.0.254
■
Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information includes IP Address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users an run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm
and so on) to enter the startup screen of the device.
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed. Figure 2-3 shows the LED indications of these Managed Switches.
WGSW-24040 / 24040R LED indication
Figure 2-3
WGSW-24040 / 24040R LED for Front Panel
■
System
LED Color Function
PWR Green
Lights to indicate that the Switch has power.
■
Per 10/100/1000Mbps Port
LED Color Function
1000
LNK/ACT
Green
Lights
to indicate the port is running in
1000Mbps
speed and successfully established.
Blink
: indicate that the switch is actively sending or receiving data over that port.
31