User’s Manual of MGSW-MGSD Series
Insert the wires into the faulty alarm contacts
1. The wire gauge for the terminal block should be in the range of 12 ~ 24 AWG.
2. When performing any of the procedures like inserting the wires or tighten the wire-clamp screws, make
sure the power is OFF to prevent from getting an electric shock.
2.1.6 Wiring the Digital Input & Output
The 6-contact terminal block connector on the front panel of MGSW-MGSD Series Managed Switch is used for Digital Input and
Digital Output. Please follow the steps below to insert wire.
1.
The MGSW-MGSD Series Managed Switch offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups
and 5 and 6 are GND (ground).
DI
DO GND
Figure 2-1-9
Wiring the Redundant Power Inputs
30
