User’s Manual of MGSW-MGSD Series
■
10 Gigabit SFP+ Slot
10GBASE-SR/LR mini-GBIC slot, SFP+ (Small Factor Pluggable Plus) transceiver module supports from 300 meters
(multi-mode fiber) to up to 10 kilometers (single mode fiber).
■
Console Port
The console port is an RJ45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP address setting, factory reset, port management, link status and system
setting. Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the
device. After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
■
Reset Button
The front panel of the MGSD-10080F / MGSW-24160F / MGSW-28240F comes with a reset button designed for rebooting
the Managed Switch without turning off and on the power. The following is the summary table of reset button functions
:
Reset Button (Press and Release)
Function
< 5 sec
: System Reboot
Reboot the Managed Switch
> 5 sec
: Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
。
Default Username:
admin
。
Default Password:
admin
。
Default IP address:
192.168.0.100
。
Subnet mask:
255.255.255.0
。
Default Gateway:
192.168.0.254
Figure 2-2:
Reset Button of
Managed Switch
1. Press the RESET button once and the
Managed Switch
will reboot automatically.
2. Press the RESET button for 5 seconds and the
Managed Switch
will be back to the factory
default mode; the entire configuration will be erased.
■
AC Power Receptacle
For compatibility with electric service in most areas of the world, the Managed Switch’s power supply automatically adjusts
to line power in the range of 100-240V AC and 50/60 Hz.
22
