Planet Networking & Communication IAP-2000PE, User Manual

Page: 44 / 82

User’s Manual of IAP-200x Series
-43-
the clients that multicast and broadcast packets buffered at the AP
will be transmitted immediately after the transmission of this beacon
frame. You can change the value from 1 to 255. The AP will check
the buffered data according to this value. For example, selecting “1”
means to check the buffered data at every beacon.
The default value is 1ms .

Fragment Threshold:
This is the maximum data fragment size (between 256 bytes and 2346
bytes) that can be sent in the wireless network before the router fragments
the packet into smaller data frames.
The default value is 2346 .

RTS Threshold:
Request to send (RTS) is designed to prevent collisions due to hidden node.
A RTS defines the biggest size data frame you can send before a RTS
handshake invoked. The RTS threshold value is between 1 and 2347.
The default value is 2347.
If the RTS threshold value is greater than the fragment threshold value, the
RTS handshake does not occur. Because the data frames are fragmented
before they reach the RTS size.

Tx Power:
The Tx Power range is between 1 and 100. In case of shortening the
distance and the coverage of the wireless network, input a smaller value to
reduce the radio transmission power. For example, input 80 to apply 80%
Tx power.
The default value is 100 .

Short Preamble:
It is a performance parameter for 802.11 b/g mode and not
supported by some of very early stage of 802.11b station cards. If
there is no such kind of stations associated to this AP, you can
enable this function.
Default: Disable .

Short Slot:
It is used to shorten the communication time between this AP and
station.

Tx Burst:
The device will try to send a serial of packages with single ACK reply
from the clients. Enable this function to apply it.

Pkt_Aggregate:
Select Disable or Enable.
Pkt_Aggregate can aggregate multiple data packets together for improving
the transmission efficiency.

ACK Timeout:
The ACK Timeout is between 1 and 100.
The default value is 100 .

Country Code:
Select the region which area you are. It provides six regions in the
drop-down list.
 FCC (1-11)
 ETSI (1-13)
 JP (1-14)