Instruction Manual
DM08
Customer password:
The customer password is intended to prevent
changes for software parameters of the DM08
by the control unit without permission.
If the operator does not enter a valid password,
all settings can be displayed but not changed.
For selecting the desired function please use
the key
▲
and
▼
.
After selecting the function Change customer
password and pressing ENTER key, the oper-
ator enters the parameter level for changing the
customer password.
The following will be displayed:
Password?
0000
The password can be changed according to the
description in section "Input window / modify a
value".
After entering a valid password, the following
message will be displayed:
Password
valid
If the entered password is not correct, the fol-
lowing message will be displayed:
Password
invalid
Notice
The factory set for the customer pass-
word is
0002
.
A valid customer password allows changes for
all software parameters that are permissible for
customers.
After the operator switched off the device or no
keystroke occurs for about 15 minutes, the au-
thorization for changes are cancelled and the
password must be entered again.
Change customer password:
After entering a valid customer password, you
may change the existing password and enter a
new one.
The prerequisite for this is the previous, correct
entry of the currently valid customer password.
For selecting the desired function please use
the key
▲
and
▼
.
After selecting the function
Change customer
password
and pressing ENTER key, the oper-
ator enters the parameter level for changing the
customer password.
The following will be displayed:
New Password?
0000
According to the description in Section "Input
window / modify a value" the changes can be
done.
Press ENTER key to confirm and save the new
password.
Notice
A copy of the password should be kept
in a safe place
.
Reactivation of a dis-
play electronics at the vendor’s site due
to a lost password is not part of our warranty!
- 30 -
PKP Prozessmesstechnik • 09/2019
