110
En
Techno Tidbits & Problem-solving
• Switch the LISTENING CH SELECT to
AUTO and switch to the HOME THX or
STANDARD listening mode (p.50-51).
• Switch the LISTENING CH SELECT to
7.1 and switch to the THX Surround EX or
Standard TX listening mode (p.50-51).
• This is not a malfunction. See the
player's manual for more details.
• Switch to STANDARD mode (p.50-51).
• Turn it/them off.
• The source has been downmixed to 48
kHz.
• Replace the batteries (p.6).
• Operate within 7 m, 30° of the remote
sensor on the front panel.
• Remove the obstacle or operate from
another position.
• Avoid exposing the remote sensor on the
front panel to direct light.
• Connect cord to the correct jack (p.76).
• Turn Locking the settings off (p.69).
• Set the lock switch to USE (p.7).
• Input the correct preset code (p.66).
• Reset the proper system settings (p.66).
• Reinsert the SR cable, making sure it is
the right jack (p.76).
• Make sure an analog connection has
been made between the units.
• This is not a malfunction.
• Reset the remote control.
(Note: In doing this, all settings in the
remote control will be reset to the default.)
(see Resetting the Remote Control, p.84)
• The listening mode is set incorrectly for
the source.
• The multi channel connections are
analog, so there is no digital transfer.
• The amplifier may be on a different mode
than STANDARD.
• One of the DIGITAL NR, MIDNIGHT and
LOUDNESS features are switched on.
• The setting for speakers other than the
surround back is set to NO.
• The remote control batteries have worn
out.
• Too far away or bad angle of operation.
• There is an obstacle between the
amplifier and the remote control.
• Strong light such as fluorescent light is
shining onto the unit's remote control signal
light-receiving window.
• A cord is connected to the CONTROL IN
terminal on this unit.
• Locking the settings on the remote
control is turned on.
• The lock switch on the remote control is
set to LOCK.
• The preset code settings are wrong.
• The battery wore out and the system
settings were cleared.
• The SR cable hasn't been connected
properly.
• The rest of the component connection
have not been made.
• The component you have hooked up is
not SR compatible.
• The remote control may be
malfunctioning.
Problem
Cause
Remedy
During playback of a
Surround EX or DTS ES
source on the AUTO setting,
the EX and ES indicators
light, but the signal is not
properly processed.
During playback of a DVD
audio source, the player
shows a transfer rate of
96kHz, but the amplifier does
not.
During playback of a DTS 96/
24 source, the display doesn't
show 96kHz.
Remote control
Cannot be remote controlled.
Other components can't be
operated with the system
remote.
The SR cable is connected,
but the connected
components can't be
operated with the remote.
Portions of the remote contol
display don’t display
correctly.
