6.3 REPLACING THE CARRIAGE WIRE
• After assembling the carriage and tonearm assemblies in
the opposite order of the previous section, replace the
carriage wire according to the following steps.
1. Adjust the length of the wire unit as shown in figure 6-4
®·
2. Attach the wire unit grommet to the spring of the worm
wheel as shown in figure 6-4 @. Then wind the wire
onto the worm wheel taking care not to let it get caught
in the worm wheel groove. Also be careful not to let the
wire overlap.
3. Holding both the wire and the worm wheel, connect the
wire to the wire guard and attach the worm wheel to
the mechanism base.
4. As shown in figure 6-4
©,
put the wire around the
pulley, and push the fixer into the carriage until it locks
with a click.
Take care not to let
the wire overlap
®
Wire unit
Grommet-F
t=:j
i---- :380mm 1 OOmml
Wire guide
Fig. 6-4 Wire Replacement
6.4 LEAD LINE DISPOSAL
1. Slide carriage to the left as far as it will go.
2. Insert enough lead line to reach from the clamp to the
motor holder. (Indicated by arrows) Insert the thickest
line last.
3. Move the carr-iage to the left and right, and check to
make sure that the lead lines don't hit the carriage.
©
Guide bar
Lead line
Clamp
Fig. 6-5 Lead Line Disposal
19