13.3 TONE ARM HEIGHT ADJUSTMENT
1. With the dust cover off, insert two 6mm spacers (one
each on the right and left) to make it the same as when
the dust cover and mechanism base are connected.
2. Place a 30cm record on the turntable, turn on the
power, and using the locate switch ( <11<11 ) move the
tone arm to within approximately 1 OOmm of the center
of the turntable.
3. Turn screw O until the tip of the needle is 5 to 7 mm
above the surface of the record.
• Turning the screw clockwise lowers the needle.
• Turning the screw counterclockwise raises the needle.
Locate switch
....
C,�
bmm spacer
Fig. 13.3 Tone arm height adjustment
13.4 Phono-Motor Speed Adjustment
1. Place the strobe sheet on the platter. Turn on the power
switch and the locate-switch ( <II <II ) to turn the phono
motor.
2. Insert a small screwdriver into the speed adjusting hole
on the bottom panel and adjust VR1 and VR2 respec
tively.
Fig. 13-4 Phono-motor speed adjustment
35