13.REGLAGE
13.1 REGLAGE DU BRAS DE PICK-UP
1. En mettant l'appareil sous tension, placer un disque
d'essai (PLS-2001 ou PLS-4001, avec le cote A vers le
haut) sur la platine de lecture de disques.
2. Presser la touche de depart/arret (ST ART /STOP) et ve
rifier la position du bras de pick-up lorsqu'il se pose sur
le disque.
3. Soulever le couvercle anti-poussiere et tourner la vis
O
de reglage jusqu'a ce que le bras de pick-up soit aligne
avec le disque.
• Lorsque le bras de pick-up se pose sur la droite du sillon
initial, (au cas ou le compte est inferieur a la tolerance
normale de compte) tourner la vis
O
ole reglage dans le
sens contraire des aiguilles d'une montre.
• Lorsque le bras de pick-up se pose sur la gauche du
sillon initial, (au cas ou le compte est superieur a la
tolerance normale de compte (tourner la vis
O
de
reglage dans le sens des aiguilles d'une montre.
• Lorsque l'on utilise le disque d'essai, la position sera
reglee pour les disques de 30 cm.
Disque d'essai
Position de reglage
PLS2001
310 ± 3 comptes
PLS4001
13 ± 6 comptes
Fig. 13-1 Reglage du bras de pick-up
36
13.2 REGLAGE DU GAIN DU SENSEUR
D'ALIGNEMENT ET DU DECENTRAGE
• Reglage du Gain
1. Deposer le couvercle anti-poussiere et le couvercle du
panneau.
2. Connecter un voltmetre CC a la broche No. 4 (GND) et
a la broche No. 5 (TRKG) de CN5.
3. Tourner la visf)dans le sens contraire des aiguilles d'une
montre et tirer le bloc du chariot en avant.
4. Mettre l'appareil sous tension et tout en poussant le
bras de pick-up vers le centre (comme indique sur la
figure), regler VR201 (TRKG) jusqu'a ce que le volt
metre CC enregistre 3V ± 0, 1 V.
• Reglage de Decentrage
5. Remettre le oras de pick-up sur la position de repos. (11
retournera automatiquement lorsqu'on le relache).
6. Pour le regler, tourner la vis
f)
dans le sens des aiguilles
d'une montre jusqu'a ce que le voltmetre CC enregistre
1,1V±0,1V.
Fig. 13-2 Reglage du gain du senseur d'alignement
et du decentrage