18
Installation Procedures
2.3 Installation Procedures
2.3.1 Transportation precautions
1
Any transportation of the unopened unit in its packaging should be done by two or more persons. To avoid injury or
damage, do not lift the package by its packing bands.
2
When transporting or storing the unit, always position it vertically - never horizontally. Horizontal transportation or storage
invalidates the product warranty.
3
In transportation or storage of products in original packing, never stack more than two units high. This warning is also
indicated on the upper face of the carton.
4
For transportation or storage, observe the warnings and instructions on the upper face of the carton.
5
Plasma display is mode of glass. Please take precautions to prevent it from being damaged.
2.3.2 Transportation of the unpacked unit
If it needs to be moved, the unit should be moved by two or more persons.
Caution
• Never move the unit by dragging it along the floor.
• Move the unit slowly, taking care to prevent scraping or striking the delicate front protective panel.
• In order to prevent adhesion of dust, remove the protective film only after all work and preparations for the installation
site, including clean-up following unpacking, are complete.
• Handles should not be removed or reattached by anyone other than the professional
installation technician or service personnel.
• If handles must be removed due to specific installation conditions, the mounting
screws should be stored carefully together with the handles. Also, when re-attaching
the handle, be sure to completely tighten the screws to ensure safety
• When moving the display, it should always be carried by two persons holding the
rear handles in the manner shown.
No!
• Never attempt to move the plasma display by holding only one of the handles.
• When installing the plasma display, do not use the handles as means of hanging the
display; also do not use them as devices to prevent tipping over (see illustration).
2.3.3 How to use the safety metal fittings and the
screws for safety metal fittings
• These are fittings for fastening the unit to a wall to prevent
tipping due to external shock when using the stand
(optional). Fasten the safety fittings to the holes in the
back of the monitor using the safety fitting mount screws.
• Be careful of the ropes when moving it.
• This device cannot be installed only on the display. Be
sure to always install it using a stand specified by this
company or a specialized unit.
• A serviceman installs this unit, so do not let anyone else
install it. The person might be injured.
Screw hole
Wall
Table Top
Safty metal fittings
Metal chain
(Not supplied)
Screw or Hook etc.
(Not supplied)
