10
En
Installation and Connections
English
Installation and Connections
Installation of the unit
Installation using the supplied display stands
Be sure to fix the supplied stands to the installation surface.
Use commercially available M8 bolts that are 25 mm
(1 in.) longer than the thickness of the installation surface.
1
Fix the supplied stands to the installation surface
at each of the 4 prepared holes using
commercially available M8 bolts.
2
S
et the panel in the stands
.
3
Attach unit using supplied washer and bolts
.
Front
Rear
PDP-505CMX:
798 mm (31-
7
/
16
in.)
(Bolt hole thread pitch)
PDP-434CMX: 880 mm (34-
11
/
16
in.)
(Bolt hole thread pitch)
110 mm (4-
5
/
16
in.)
Use a 6 mm (
1
/
4
in.) hex
wrench to bolt them.
CAUTION
This display panel weighs 67 pounds (30 kg) and has little front-
to-back depth, making it very unstable when stood on edge. As a
precaution, two or more should work as a team when unpacking,
moving, or installing the plasma display.
Installation using the optional PIONEER stand or
installation bracket
÷
Please employee professional assistance when mounting or
installing the panel. Your Pioneer representative or the dealer
who sold the display can help you find an installation specialist.
÷
When installing, be sure to use the bolts provided with the
stand or installation bracket.
÷
For installation procedure details, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
÷
When possible, please install using parts and accessories
manufactured by PIONEER. PIONEER is not responsible
for accident or damage caused by the use of parts and
accessories manufactured by other companies.
÷
For custom installations, please consult a qualified installer or
with the dealer where the unit was purchased
.
Wall-mount installation of the unit
This unit is designed with bolt holes for wall-
mount installation, etc. The installation holes
are shown in the accompanying illustration.
÷
Attach in 4 or more locations above, below, left, and
right of the center line.
÷
Use bolts that are long enough to be inserted 12 mm
(
1
/
2
in.) to 18 mm (
11
/
16
in.) into the main unit from the
attaching surface; for both A holes and B holes. Refer
to the sideview diagram in the accompanying illustration.
÷
This unit is constructed with glass; be sure to install
it on a flat, unwarped surface.
CAUTION
To avoid malfunctions, overheating of this unit, and possible fire
hazard, verify that the unit's vents are not blocked after being
installed. Also, as hot air is expelled from the air vents, check for
deterioration or dirt build up on the wall or other objects behind
the panel.
CAUTION
Please use only an M8 (Pitch = 1.25 mm) bolt. (Only this size
bolt provides the necessary strength for proper installation.)
CAUTION
This display unit weighs 67 pounds (30 kg) and has little front-
to-back depth, making it very unstable when stood on edge. As a
precaution, two or more should work as a team when unpacking,
moving, or installing the plasma display.
CAUTION
This unit incorporates a thin design. To ensure safety if installed
in a location subject to vibrations or shaking, take measures to
prevent the unit from tipping over.
Always install the supplied display
stands according to the dimensions
shown in the accompanying illustration.
