2
Turn MULTI-CONTROL to select
PAIRED PHONE.
#
Push
MULTI-CONTROL
up or down to select a
desired phone.
#
Push
MULTI-CONTROL
left or right to display
the BD address, group and ID number.
3
Press MULTI-CONTROL to start connec-
tion.
PIN code is set to
0000
as the default. You can
change this code in the initial setting. Refer to
Entering PIN code for Bluetooth wireless con-
nection
on page 51.
While connecting,
CONNECTING
is displayed.
If the connection is established,
CONNECTED
is displayed.
After connected, this unit automatically
changes to
PH.BOOK DL
(phone book down-
load confirmation) display.
#
If the connection fails,
ERROR
is displayed. In
this case, check the cellular phone and try again.
4
Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push
MULTI-CONTROL
left or right to select
NO
(No) or
YES
(Yes).
Press
MULTI-CONTROL
to decide.
When you select
YES
, this unit changes to
PH BOOK DOWNLOAD
and the download op-
eration automatically begins. After complet-
ing,
DATA DOWNLOADED
is displayed.
#
When you select
NO
, the display reverts to
normal.
Disconnecting a cellular phone
1
Display the connection menu.
Refer to
Introduction to connection and pairing
on page 30.
2
Use MULTI-CONTROL to select
DISCONNECT PHONE.
3
Press MULTI-CONTROL to disconnect a
cellular phone from this unit.
After disconnection is completed,
DISCONNECTED
is displayed.
Pairing a connected cellular phone
Pairing is usually performed automatically dur-
ing the connection operation. You only need to
perform this operation manually when your
phone is connected temporarily for any reason.
We recommend you pair the phone to this unit
to make best use of the technology.
1
Display the connection menu.
Refer to
Introduction to connection and pairing
on page 30.
2
Use MULTI-CONTROL to select
SET PHONE.
3
Push MULTI-CONTROL up or down to
select a pairing assignment.
P1
(user phone 1)
—
P2
(user phone 2)
—
P3
(user phone 3)
#
Push
MULTI-CONTROL
left or right to switch
the BD address and device name.
#
If a phone is already assigned to the user
phone number, the new phone will overwrite the
old one.
#
As you select each assignment, you can see
whether or not a phone is already paired. If the
assignment is empty,
NO DATA
is displayed.
4
Press MULTI-CONTROL to pair the cur-
rently connected phone.
When pairing is completed,
COMPLETED
is
displayed.
#
If the pairing fails,
REGISTER ERROR
is dis-
played. In this case, return to step 1 and try
again.
Deleting a paired phone
1
Display the connection menu.
Refer to
Introduction to connection and pairing
on page 30.
2
Use MULTI-CONTROL to select
DELETE PHONE.
Operating this unit
En
33
Section
02
Operating
this
unit
