The Initial Setup menu
16
135
En
Component Video
Out
Interlace •
Select if your monitor/TV is not compatible with
progressive-scan video.
Progressive
Select if your monitor/TV is progressive-scan
compatible. Check the operating instructions that
came with your monitor/TV if you’re not sure.
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than
RGB
.
If your TV is incompatible with progressive scan video and you select
Progressive
, you will not be able to see any
picture at all
. In this case, press
(
PLAY
) while holding down the
(
STOP
) button on the front panel to
switch to
Interlace
(this also switches Screen Resolution
on page 142
to the default setting).
When an HDMI device is connected and Video Priority Mode is set to
HDMI
, the Component Video Out setting is
automatically set to
Interlace
.
AV1 Out
Video •
Sets the
AV1(RGB)-TV
SCART output to standard
composite video (compatible with all TVs).
S-Video
Sets the
AV1(RGB)-TV
SCART output to S-video.
Recommended if you are using a long SCART cable.
RGB
Sets the
AV1(RGB)-TV
SCART output to RGB. Good
quality but check your TV for compatibility. Note that
on this setting signals from the built-in tuner and
from external inputs is not output when the recorder
is in TV mode.
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case
either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on
page 160).
The Component Video Out setting (see above) has no effect when AV1 Out is set to
RGB
.
AV2/L1 In
Video •
Sets the
AV2 (INPUT 1/DECODER)
SCART input to
standard composite video.
S-Video
Sets the
AV2 (INPUT 1/DECODER)
SCART input to
S-video.
RGB
Sets the
AV2 (INPUT 1/DECODER)
SCART input to
RGB.
Decoder
Use this setting if you connected a decoder to the
AV2 (INPUT 1/DECODER)
SCART connector. For
scrambled channels, make sure that the channel
Decoder
setting is set to
On
. (See
Manual CH Setting
page 134.)
When the Input Line System is set to
525 System
,
RGB
cannot be selected.
Even when set to
RGB
. depending on the connected device, the input signal may be composite video.
Setting
Options
Explanation
DVR645H_WY_EN.book 135 ページ ２００６年７月５日 水曜日 午前１０時２５分
