Pilz PSEN cs6.2p, Operating Manual, Page: 34 / 50

PSEN cs6.2p
Operating Manual PSEN cs6.2p
1003430-EN-06
| 34
[4]
DEVICE
SAFETY GATE
INPUT
DEVICE
SAFETY GATE
INPUT
Fig.: Applying the screw cover [4] on the switch
Procedure:
1. Align the safety switch and tighten the screws.
2. Actuator PSEN cs6.1
Align the actuator and tighten the screws.
3. Use the seals to close the mounting holes on the sensing face of the safety switch (see
diagram, [4]).
Use in operating heights higher than 2000 m above sea level
When using the PSEN cs6.2p note the reduced max. ambient temperature of +60 °C at a
height of 2000 m to 4000 m.
Adjustment
} The stated operating distances (see Technical details [ 39] ) only apply when the
safety switch and actuator are installed facing each other in parallel. Operating distances
may deviate if other arrangements are used.
}
Note the maximum permitted lateral and vertical offset (see Operating distances [ 11]
and Lateral and vertical offset [ 13] ).