PSEN cs6.2p
Operating Manual PSEN cs6.2p
1003430-EN-06
| 29
[5]
[5]
[7]
[1]
[2]
[3]
[6]
[9]
[10]
[10]
8
4
0
-4
-8
-12
-16
-20
-24
-28
12 8 4 0
12
16
12
8
4
0
[7]
8
4
0
-4
-8
-12
-16
-20
-24
-28
12
16
-30
-30
[8]
[4]
6,5
6,5
[11]
[12]
[4]
-9,4
-9,4
Legend
[1] Hysteresis
[2] Typical operating distance S
O
[3] Typical release distance S
r
[4] Offset in mm (distance of the middle of the actuator to the zero line in the grid)
[5] Operating distance in mm
[6] Response range
[7] Connector on the safety switch
[8] Limit of response range, position of gate hinge
[9] Status of LED
[10] Sensing face of the actuator, labelled with Pilz logo
[11] Distance from the front edge of the safety switch to the limit of the response range
(position of the gate end stop) = 15.9 mm
[12] Distance from the rear edge of the safety switch to the limit of the response range
(position of the gate end stop) = 10.5 mm
Safety switch
}
Safety switches should only be secured using M4 screws with a flat head (e.g. M4
cheese-head or pan head screws).
Procedure:
1. Provide the mounting surface with two drill holes for fastening the safety switch (see
2. Use a screw to ix the safety switch to the mounting surface.
Make sure that the safety switch marking that is to be used for operation can be oper-
ated using the actuator from the right side.
3. Do not fully tighten the second screw on the safety switch.