21
102. You may wish to paint the interior of
the fiberglass cowl with a matt finish black
paint.
103. Put the dummy motor into the cowl but
DO NOT
glue in place at this time.
104. The cowl mounting ring is pre-installed
at the factory. Installation is by placing the
cowl over the cowl mount screws and
rotating slightly in a counter-clockwise
direction to hold in place.
105. Before flying you may choose to
tighten several of the screws by using a
long Phillips screwdriver from the front of
the cowl.
106. Locate the wooden AXI motor mounts
107. There is a light line burned on the 2
side pieces, this line is 15mm from one
edge of the plywood. If you are using a
5330 series motor, assemble the parts
without modification.
108. If you are using the 5345 series motor
you will need to cut off 15mm of each side
to achieve the proper motor distance from
the firewall.
109. Install the motor on the front mount
and screw the front face to the sides, do
not glue the front plate to the sides.
110. Epoxy this unit to the firewall box using
the centering reference that is burned into
the firewall.
111. If you wish to screw this mount to the
firewall block, pre-drill some pilot holes
and screw the mount in place from inside
the fuselage.