10
46. Photo shows the elevator and rudder
controls. Tighten the lock nut to maintain
the settings.
47. Clip the excess wire in front of the crimp.
48. Locate the pre-painted wire landing gear
parts as well as the 2 wooden fillers and
the 2 nylon landing gear straps and
screws.
49. Insert the landing gear into the pockets on
the fuselage making sure to avoid
puncturing the covering with the rear
landing gear wire.
50. Seat gear fully into position and insert the
rear wire in the pre-drilled hole near the
front edge of the lower wing. (See photo)
51. Spread epoxy on the sides and edges of
the wooden fillers.