PI L-402 Series, User Manual, Page: 22 / 43

5 Installation
18 Version: 1.2.0 MP164E L-402 Mniature Stage
5.5 Connecting the L-402 to a Controller
NOTICE
Damage if an incorrect controller or motor cable is connected!
Connecting the L-402 to an unsuitable controller or using an unsuitable motor cable can
cause damage to the L-402 or controller.

Only connect the L-402 to a suitable controller (p. 7).

To connect the L-402 to the controller, only use a motor cable that is suitable for the
controller.
Requirements

You have read and understood the general notes on installation (p. 11).

You have installed the controller.

You have read and understood the user manual of the controller.

The controller is switched off.
Tools and accessories

If necessary:
− Drive/encoder cable to be used as extension cable and/or adapter cable, suitable
for the controller used (p. 7)
−
Four spacer bolts, part of the mounting hardware (incl. in scope of delivery (p. 7))

Suitable screwdriver for the locking screws of the connectors.
Connecting the L-402 to a Controller
1. Remove the ESD protection from all connectors of the L-402.
2. Connect the L-402 to the controller.
For connecting an extension/adapter cable, it might be required to affix the provided
UNC bolts to the corresponding connector; using a hex key AF 5mm or a compliant tool
(see schematic illustration below). Note that the tightening torque must not exceed 2.5
Nm .
3. Use the integrated screws to secure the connections against accidental disconnection.