7 Start-Up
C-863 Mercury Controller
MS205Equ
Version: 2.0.0
49
Figure 9: Start up controller – Connect controller
2. Select
C-863
in the field for controller selection.
3. Select the
USB
tab on the right side of the window.
4. On the
USB
tab, select the connected C-863.
5. Click
Connect
to establish communication.
If communication has been successfully established, the
Select connected
stages
dialog opens.
If communication could not be established, look for a solution to the problem
in "Troubleshooting" (p. 85).
7.4.3 Establishing Communication for a Networked Controller
The procedure for PIMikroMove and for PITerminal is described in the following.
INFORMATION
If you are establishing communication with a networked controller via PITerminal, the
address of the controller to be addressed is required in every command line. Details
see "Target and Sender Address" (p. 69).
Use PITerminal to test communication with networked controllers.
