Technology Module TM StepDrive 1x24..48V/5A
MA 1303-A007 EN
48
6.5.6 I/O Addresses
You can assign the base addresses for the control and feedback interfaces. Your program
logic uses the values stored in these addresses to control the TM StepDrive output and to
read the feedback signals from the module.
Operating mode
Input addresses
(I-addresses)
Output addresses
(Q-addresses)
Positioning
12-byte
8-byte
Technology object
18-byte
10-byte
Output Addresses
Start address: Assign of a start address up to 8 (or 10) bytes (Q addresses) for the control
interface of a channel.
End address: The end address of the control interface is a calculated read-only field
Input Addresses
Start address: Assign of a start address up to 12 (or 18) bytes (I addresses) for the feed-
back interface of a channel.
End address: The end address of the feedback interface is a calculated read-only field.
