phytron phyMOTION INAM01.1, Translation Of The Original Manual

Page: 18 / 45

Manual INAM01 / INAM02
MA 1275-A004 EN 18
WARNING – Serious injury from electric shock!
During electrical installation cables, connectors, etc. can be live.
- Before starting wiring, make sure that none of the power supplies are
connected to the primary side of the mains supply. Isolate the power
supplies from the mains or remove the appropriate fuses.
- All modules must be inserted and screwed into the phyMOTION
TM
housing
before powering up. If necessary, unoccupied module slots must be covered
with the supplied blank front plates.
Never operate the equipment when open.
- Do not plug or unplug the modules while powered.
- Do not plug or unplug the connectors while powered.
- If the equipment was energised, wait 3 minutes after power off to allow the
capacitors to discharge and ensure that there are no residual charges on
cables, connectors and boards.
Make sure not to leave free slots in between modules so the module addressing sequence can
work correctly.
Identify the correct slot position for your INAM01 referring to your order and documentation. The
INAM01 needs at least a preceding power module (POWM01, POWM02), the main controller
module (MCM01) and an additional indexer (EXAM01).
Push the module carefully into the guide rail until the rear contacts the housing frame of the
phyMOTION
TM
.
In the last few millimetres the module’s plug has to match with the backplane’s socket. You should
be able to push in the module with light pressure. In case you experience problems move the
module’s front plate slightly to the left and to the right while pushing in the module, so that the
plug’s pins can slide into the backplane’s socket.
As soon as the module’s front plate contacts the housing’s frame the module is integrated properly
and can be fixed with two electro-conductive bolts.
Now you can start with the electrical installation.
5.1.2 INAM02
The INAM02 module is only installed in phytron’s plant.