Getting
Started
© PHYTEC Meßtechnik GmbH 2009 L-647e_2
15
2.2
Installing Rapid Development Kit Software
The current version of the PHYTEC Tool-CD does not provide a setup
program for automatic installation. You will need to manually copy
the demos, manuals, and other support documents for this Rapid
Development Kit to your local hard drive.
All path and file statements within this QuickStart Instruction are
based on the assumption that you choose
C:\PHYBasic
as the default
path when copying files from Tool-CD to hard drive.
•
Copy the the entire
PHYBasic
folder from the
PHYTEC
phyCORE-MPC565 Tool-CD
to you local hard drive. Make sure
to remove the read-only attribute from all files copied to you hard
drive.
2.3
Interfacing the phyCORE-MPC565 to a Host-PC
Connecting the phyCORE-MPC565 (part # PCM-019-xxxx), mounted
on the PHYTEC Development Board (part # PCM-991), to your
computer is simple:
•
If the phyCORE module is not already installed, mount it onto the
Development Board's Molex connector (X1) as shown in the
figure below. Ensure that pin 1 of module matches pin 1 of the
receptacle on the Development Board.
Ensure that there is a solid connection between the module's pins and
the Development Board receptacle. If the phyCORE module is
removed from the Development Board, take precautions to properly
mount the module when it is reattached to the Development Board.
Pin 1 on the phyCORE module (denoted by the hash stencil mark on
the PCB) should be matched to the footprint receptacle on the
Development Board marked by "X1" on the PCB. Also take
precautions not to damage the connectors when the phyCORE is
removed from and inserted onto the Development Board.
