phyCORE-MPC565 QuickStart Instructions
14
© PHYTEC Meßtechnik GmbH 2009 L-647e_2
The default destination location is
C:\Program Files\Freescale\CodeWarrior EPPC 5xx V8.7
. All path
and file names within this QuickStart Instruction are based on the as-
sumption that you accept the default install paths and drives. We
recommend that you accept the default destination location.
Once installation of CodeWarrior is complete, you need to manually
copy additional support files from our ftp-server to the Program Files
for CodeWarrior on your host-PC. These files enable initialization of
and communication to the PHYTEC phyCORE-MPC565 target
hardware from within the CodeWarrior IDE.
You need to enter the path
ftp://ftp.phytec.de/pub/Products/
phyCORE-MPC565/CW8.7/
into your browser and then
•
replace the files
phyCORE-MPC565_internal_flash.xml
and
phyCORE-MPC_external_flash.xml
located in:
C:\Program Files\Freescale\CodeWarrior EPPC 5xx V8.7\
bin\Plugins\Support\Flash_Programmer\EPPC
with those from our ftp-server.
•
Next, replace the file
phyCORE-MPC565_init.cfg
located in:
C:\Program Files\Freescale\CodeWarrior EPPC 5xx V8.7\
PowerPC_EABI_Support\Initialization_Files\5xx
with that from our ftp-server.
Note:
In order to allow proper communication between the host-PC's parallel
printer port and the BDM interface on the phyCORE Development
Board for debugging and code download configure the printer port to
be one of the following: SPP, Normal, Standard, Output Only,
Unidirectional, AT. Try to avoid ECP, EPP or PS/2
bi-directional. The printer port mode is selected in your System BIOS.
