phyCORE-MPC565 QuickStart Instructions
6
© PHYTEC Meßtechnik GmbH 2009 L-647e_2
•
UART port:
two RS-232 transceivers for channel A and
B (RxD/TxD); also configurable as TTL
•
CAN port:
two CAN transceivers 82C251 for channels
A and B; also configurable as TTL
•
Ethernet port:
10 MBit/s CS8900A controller (I/O mode)
•
System-EPLD:
Lattice device ispMACH LC4064,
in-system programmable, 10 free I/O
signals, e.g. for additional /CS generation
•
I
2
C Real-Time Clock with calendar and alarm function
•
power-down/wake-up support via RTC or external signal
•
JTAG/BDM/Nexus test/debug port
•
industrial temperature range (-40…+85
°
C)
The phyCORE-MPC565 Development Board is fully equipped with
all mechanical and electrical components necessary for the speedy and
secure insertion and subsequent programming of the
phyCORE-MPC565 module with high-density (0.635 mm pitch) pin
header connectors. RS-232 and CAN interface signals extend from
the module to dual-stacked DB-9 connectors on the Development
Board, while Ethernet signals extend to an RJ-45 connector. A 40-pin
Nexus connector provides a debugging interface (an unpopulated
50-pin Nexus connector is also available).
