Photron FASTCAM Mini CX Series, Hardware Manual

Page: 44 / 66

30
FASTCAM Mini CX100
1
.5
Bu
ilt
-In
B
a
tt
e
ry
1.5. Built - In Battery
The system is loaded with a built-in battery for driving the system, and so the system can run for a while even after
an unforeseen cut off of the power supply.
At the condition of the product shipment, the battery takes for about four hours before full charge and is capable to
run the sysmtem for approximate 30 minutes.
• The system is shipped with the built-in battery discharged to ensure the safely in use. Charge the battery full
before using.
•
It is recommended to use the fully charged battery as far as possible.
•
Be sure to discharge the battery to the “Low” level for an air transportation of the system.
• Use the accessory AC adapter.
•
Charge of the built-in battery is restricted when the temperature inside the body is 50 deg C or higher. The
temperature will reach 50 deg C around 30 to 60 minutes after powering up depends on the environment of
usage. Be careful especially when charging while the camera is running.
• The built-in battery is a consumable. Use it after checking the drive time beforehand when to conduct an
important testing. Contact Photron if the drive time is shortened.
Do not charge or discharge the battery in a location where the temperature gets unusually hot
(near the fire, in sun-heated cars, or the like) or where a flammable gas can be emitted.
Doing so can raise to high temperature, emit smoke or cause fire.
Stop charging the battery when the charge level will not reach full even if the specified charge
time is fulfilled.
Continuing so can raise to high temperature, emit smoke or cause fire.
Warning
Warning