Photron FASTCAM Mini CX Series, Hardware Manual

Page: 30 / 66

16
FASTCAM Mini CX100
1
.2
Pa
rt
Na
m
es
Connector
Name
Signal Pin No
Body side connector’s
model name
(Manufacturer) Cable side connector’s
model name
(Manufacturer)
Input side
connector
I/O PORT
GND 1
EZG.2B.314.CLN
(LEMO) FGG.2B.314C.CLAD72Z
(LEMO)
-
DC IN 2 LEMO
Remote On 3 BNC
Sync In 4 BNC
Sync Out 5 BNC
Reserved 6
-
Trigger In 7 BNC
Expose Out 8 BNC
Ready Out 9 BNC
Reserved 10
-
Reserved 11
-
Signal GND 12
-
Reserved 13
-
Reserved 14
-
•
Pin 12’s SIGNAL GND signal is the BNC ground.
When using the connector pins directly, refer to the chart above and ensure the wiring is correct.
If the wiring is incorrect, not only is there the danger of the system malfunctioning, but also of
fire and electric shock.
Do not use a power supply which does not meet the system’s specifications, or a power supply
you cannot guarantee the safety of.
By using a power supply out of the system specifications, not only is there the danger of the
system malfunctioning, but also of fire and electric shock.
Apply the rated voltage within the appropriate range regulated in IEC/EN 61010-1 third edition
(based on Cl.6.3 and Cl.2.5). The main circuit is insulated double or with a reinforced insulation
against the power supply.
Warning
Warning
Warning