Photon Focus MV3-D640I-M01-144-CL, User Manual, Page: 38 / 121

5 Counter & Timer
Line input source has additionally a activation configuration, which needs to be set
accordingly. Following configuration values are available:
Rising Edge Counter counts rising edges on the selected line input.
Falling Edge Counter counts falling edges on the selected line input
Both Edges Counter counts both edges on the selected line input
Activation configuration has only effect when line input is selected as a counter
event source, otherwise this configuration is ignored.
The counter can be temporarely switched off, if the counter event source is set
to off. It continue counting events as soon as counter event source has been
selected again.
5.1.6 Counter Trigger Source
The counter trigger source selects the signal which will be the used to start the counter. The
following signals sources are available:
Off
Disables the counter trigger
Acquisition Trigger Starts with the reception of the acquisition trigger event.
Acquisition Start
Starts with the reception of the acquisition start event.
Acquisition End Starts with the reception of the acquisition end event.
FrameTrigger Starts with the reception of the frame trigger event.
Frame Start Starts with the reception of the frame start event.
Frame End Starts with the reception of the frame end event.
Frame Burst Start Starts with the reception of the frame burst start event.
Frame Burst End Starts with the reception of the frame burst end event.
Exposure Start
Starts with the reception of the exposure start event.
Exposure End Starts with the reception of the exposure end event.
User Output 0 ... 7
Starts and counts events as long as the selected user output bit is asserted.
When the counter is started, it ignores counter events as long as the corresponding user
output bit is deasserted (see Section 4.7).
Counter 0 ... 3 Start Starts with the reception of the chosen counter start event.
Counter 0 ... 3 End Starts with the reception of the chosen counter end event.
Timer 0 ... 3 Start Starts with the reception of the chosen timer start event.
Timer 0 ... 3 End Starts with the reception of the chosen timer end event.
Software Signal Pulse 0 ... 7
Starts with the reception of chosen software signal pulse event
(see Section 4.7).
38 of 121 MAN076 09/2017 V1.0